Cameo XNODE 8 Manual De Usuario página 6

9 NEUTRIK
powerCON output socket.
USB TYPE-B SOCKET
10
for firmware updates.
MAINS CONNECTION
The user must supply a suitable power cable. He may then either hard-wire the power cable to the building's electrical installation, provi-
ding an easily accessible power on/off switch close to the device, or install on the power cable a grounding-type (earthed) mains plug that
is suitable for the local power outlets, following the power plug manufacturer's instructions. Consult a qualified electrician, if you have any
doubts about the proper installation.
A blue Neutrik powerCON NAC3FCA cable mount connector must be used to supply power at the XNODE 8's power input socket.
Warning! For protection against dangerous electrical shocks, the device must be grounded (earthed). The local AC power
source must be supplied with both overload and ground-fault (earth fault) protection.
Important! Only attach or remove a Neutrik powerCON connector while it is connected to the mains to apply or cut power
in an emergency, as by doing so may cause arcing at the terminals that will damage the connectors.
POWER OUTLET
Warning! The total current load of all devices connected to the AC mains power outlet of the XNODE 8 must not exceed
19.8 amperes.
 A power cable that meets the requirements specified in the safety instructions section of this manual must be used to connect the
XNODE 8 to AC mains power and to connect other devices to the power outlet.
 A light-grey Neutrik powerCON NAC3FCB cable-mount connector must be used to draw AC mains power from the XNODE 8's power outlet.
 No matter what the AC mains power voltage is, the current drawn by all the devices that draw AC mains power from the power outlet of
an XNODE 8 must not exceed a total of 19.8 amperes.
DMX CONNECTIONS
Depending on the version, the XNODE 8 is equipped with 5-pin or 3-pin XLR connectors or with Neutrik etherCON RJ45 connectors.
XLR CONNECTORS
Pin Connection
1 Com
2 Data -
3 Data +
4 Not connected
5 Not connected
6