Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
Operating Instructions
Remote control
The remote control and control panel will look like one of the following pictures.
2
3
6
4
POWER
Operation starts when this button is pressed and stops when you
press the button again.
OPERATION MODE SELECTOR
Push the MODE button to rotate between Energy Saver / Cool / Fan / Heat.
Energy Saver -
Approximately every 3 minutes the fan will turn on and check the room air
temperature if cooling is needed.
Compressor runs and cools the room.Use the
Cool -
set the desired temperature and circulation fan speed.
Fan circulates air but compressor does not run. Use the FAN button to set
Fan
-
the desired fan speed.
Heater runs and heats the room.
Heat -
ON/OFF TIMER
- when the air conditioner is off, it can be set to automatically turn
Delay ON
on from 1 to 24 hours at its previous mode and fan settings.
Delay OFF - when the air conditioner is on, it can be set to automatically turn
off from 1 to 24 hours.
FAN SPEED SELECTOR
Use to set the fan speed to Low (F1), High (F2).
16 Room Air Conditioner
16 Room Air Conditioner
5
The fan stops when the compressor stops cooling.
REMOTE CONTROLLER
5
7
1
3
and FAN buttons to
Power
1
Temp
Fan Speed
4
Timer
Mode
2
Publicidad
