Silver King SKF72D/C10 Manual Tecnico página 2

Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the most reliable equipment in the industry
today. Please read this manual and the accompanying warranty information before operating your new Silver King unit.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to inspect for possible freight damage following the instructions printed on the exterior of
the container. Report any damages to the carrier responsible for transportation and promptly present a claim for any evidence of mishandling. Save
all packaging materials if a claim is filed.
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. This covering can be readily
stripped before installation. After removing this covering, wash the interior and exterior surfaces using a warm, mild soapy water solution and a
sponge or cloth, rinse with clean water and dry.
Legs/Casters
The unit comes with casters. To install them, tip the unit on its back and attach the casters with bolts provided in the base of the unit. The casters
with brakes should be installed at the front of the cabinet. Make sure that they are installed tightly to prevent future thread wear. Periodically check
for tightness.
Drawers
To remove the drawers for cleaning, simply open them fully, release gray tabs, and lift up on the front of the drawer to remove the front wheels from
the drawer tracks, continue to slide the drawer out until the rear wheels reach the end of the tracks and lift the drawer out of the tracks. To reinstall
the drawer, insert the rear wheels of the drawer into the drawer tracks and slide the drawer back until the front wheels on the drawer can be inserted
into the track, push the drawer into the cabinet, pull the drawer back out and press the gray tabs back into the locked position. The drawer pans can
be removed by lifting them out with the drawer extended. The rolling drawer tracks can be removed for cleaning when the drawers are removed from
the cabinet. Pull each track out half way, push the gray tab on the inside rear of the track back, and pull the track out.. The drawer slide system is
rated for a maximum load of 200 pounds. The drawers are not designed for or intended to be used as a surface to stand on. At no time should the
drawers be extended and used as a platform for standing on to reach elevated equipment.
Location
When locating your new freezer, convenience and accessibility are important considerations, but the following installation guidelines must be
followed:
• Always avoid placing the freezer adjacent to an oven, heating element or hot air source that would affect the operation of the unit.
• For proper ventilation, the bottom front and rear of the unit must not be obstructed. The unit must be on legs or casters to raise it off the floor.
The unit can be installed tight on the sides.
• The unit must be level or tilted backwards slightly.
All manuals and user guides at all-guides.com
TECHNICAL MANUAL
SILVER KING FREEZER
MODEL SKF72D
1