Nash Siren R3+ Guia Del Usuario página 5

Tone:
Hold down Power button and short press the X button to
scroll through the five tone options. The Tone being heard
is the Tone being set.
LED Colour:
Press and hold the Function (X) button, then short press
the Power button. There are five LED colour options
available, Release the Function (X) button to set the
selected colour.
LED colour options are:
Red > Green > Blue > Purple > White
Indicator Compatibility:
The R3+ Alarm has an MMCX bayonet push and twist
connection for use with all Nash illuminated indicator
ranges featuring this fitting.
The supplied stainless M5 thread adaptor connects
to the MMCX fitting to offer an integral connection for
all accessories featuring an M5 thread including Nash
Bobbin and Slap Head Cords, Chains and Strong Arms.
NOTE: When the MMCX connection is not in use the supplied
rubber bung must be inserted to prevent water ingress.
Night Glo Function
Press and hold X and Power buttons together for 2
seconds to enable/disable the pulsating Night Glo
function. When the Night Glo function is turned on you
will hear two bleeps of increasing pitch. When the Night
Glo function is turned off you will hear two bleeps of
decreasing pitch.
NOTE: Nash Bobbin Glow Pipes T5019 and T5020 are not
compatible with R3+ alarms.
Low battery warning: :
The R3+ alarm self diagnoses power every 30 minutes
when switched on. When low power is detected the R3+
alarm emits five consecutive 1 second beeps to warn
battery power is low. Replace immediately to retain
full functionality. Note that the first warning of reduced
battery power will be dimmer LEDs.
Plus Instruction Manual.indd 5 Plus Instruction Manual.indd 5
5
28/07/2022 08:5 28/07/2022 08:5