Nash Siren R3+ Guia Del Usuario página 7

1. Vibrate and LED flash: Receiver muted, vibrate and
LEDs on.
2. LED flash only: Receiver muted. LEDs on. No sound
and no vibrate.
3. Beep, LED flash and Vibrate: Sound, LED and
vibration turned on.
4. LED flash and a beep: Sound and LEDs on.
Anti-Theft Alarm:
Long press of A Button on Receiver. Two beeps will be
heard. An increasing pitch signifies Anti-Theft is ON.
Decreasing pitch is Anti-Theft OFF. Factory setting is
Anti-Theft OFF.
The Anti-Theft alarm alerts you if an R3+ head is turned
off whilst your Receiver is on. Once triggered, a long
press of the A button on the Receiver stops the alarm
sounding.
Programming R3+ Heads to R3+ Receiver:
1. Press and hold Power and Volume buttons together
for 3 seconds until a beep is heard.
2. LED 1 will light and stay lit. Sounding an R3+ alarm
will pair it to that channel. Pairing is confirmed when
the LED on the Receiver flashes. Short press the
Power button to light the second LED. R3+ alarms can
be sequentially paired in this way through channels
one to four.
3. Once you have paired all the R3+ heads you require
press and hold the Power button for 3 seconds to
save the pairings and exit programming, signified by
a double beep.
4. The fifth channel can be paired with up to 32 different
R3+ alarms. To pair R3+ heads with the fifth channel
enter programming mode by pressing and holding
Power and Volume buttons together for 3 seconds
until a beep is heard.
5. Short press the Volume button, and the fifth LED on
the Receiver will light and stay lit. When an R3+ alarm
sounds and is successfully paired the LED flashes.
Plus Instruction Manual.indd 7 Plus Instruction Manual.indd 7
7
28/07/2022 08:5 28/07/2022 08:5