Philips Azur Elite GC5030 Serie Manual Del Usuario página 6

English
10
Problem Possible cause
The steam setting The steam button changes
does not change steam settings only
when I press the when the iron is tilted. In
steam button on horizontal position, the
top of the handle. steam button serves as
a trigger to release extra
steam in any setting.
The ironing board Steam has condensed on
cover becomes the ironing board cover
wet or there are after a long ironing session.
water droplets on
the garment during
ironing.
You have an ironing board
cover that is not designed
to cope with the high steam
rate of the appliance.
Water droplets drips You have used the steam
onto the garment boost function too often
during ironing. within a short period.
You have not closed the
water tank lid properly.
You have not insert
the Quick Calc Release
collector properly back
to the appliance (specific
types only).
You have put a chemical
into the water tank.
The iron does not You have used the steam
produce a steam boost function too often
boost within a short period.
You are ironing before the
iron gets ready
Dirty water Hard water with impurities
and impurities or chemicals has formed
come out of the flakes inside the soleplate.
soleplate during
ironing.
Solution
Tilt the iron up slightly and press the steam
button to change steam setting.
This is designed to ensure the consumers do
not accidentally change the steam setting while
ironing.
Replace the ironing board cover if the foam
material has worn out. You can also add an extra
layer of felt material under the ironing board
cover to prevent condensation on the ironing
board. You can buy felt in a fabric shop.
Put an extra layer of felt material under the
ironing board cover to prevent condensation
on the ironing board. You can buy felt in a fabric
shop.
Continue ironing in horizontal position and wait
a while before you use the steam boost function
again.
Press the lid until you hear a 'click' .
Stop ironing and let the iron cools down for at
least 1 hour. Take out the Quick Calc Release
collector. Insert it back into the appliance and
ensure the collector is in-line with the surface of
the appliance. Push down the lever ("click").
If the Quick Calc release tray is damaged,
contact a consumer care center in your country
(see the world wide guarantee leaflet for contact
details).
Rinse the water tank and do not put any
perfume or chemicals into the water tank.
Continue ironing in horizontal position and wait
a while before you use the steam boost function
again.
Wait until the iron is ready (the light on the
display panel stops flashing).
Perform Quick Calc Release (specific types only)
or Calc-Clean (specific types only).
See chapter "Cleaning and maintenance".