Safety Instructions - Fox F36-420 Manual De Instrucciones

WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY WHEN USING
ELECTRICAL TOOLS, OPERATORS SHOULD ALWAYS OBSERVE BASIC SAFETY
PRECAUTIONS AS WELL AS THE THOSE INDICATED IN THIS MANUAL.
Read carefully all the instructions before use this product and keep them safe for future reference.
Operations carried out using a power tool can become dangerous for the operator if safe and adequate
operating standards are not observed. As with any electrical machinery with moving parts, use of the tool
entails certain risks. If the tool is used as indicated in this manual, with due concentration on the work being
performed, in observance of safety regulations and wearing appropriate personal protective equipment, the risk
of accidents and injury is almost inexistent. Possible residual risks include:
1. direct or indirect contact with electric shock
2. injury caused by contact with rotating parts
3. injury caused by contact with sharp parts
4. injury caused by flying parts of the tool or the material being handled
5. damage to hearing caused by noise
6. harm caused by dust inhalation
7. injury caused by incorrectly installed tools
The safety equipment envisaged on tools, such as guards, casings, workpiece pusher, clamping devices and
personal protective equipment such as goggles, dust masks, ear defenders, safety footwear and gloves can
help reduce the risk of injury. However, not even the best safeguards can protect against a lack of common
sense or failure to operate with due care and attention. Always use your common sense and take all necessary
precautions. Only perform operations which you are sure are safe. DO NOT FORGET: safety is everyone's
responsibility.
This tool has been designed for a specific use. FEMI urges you not to modify it or use it for any purpose other
than those for which it was specifically designed and built. In the event of any doubt concerning specific
applications, DO NOT use the tool until you have contacted FEMI and received the necessary clarification.
PERSONNEL AUTHORIZED TO USE THE MACHINE
This machine has been designed and manufactured to be used by qualified personnel with adequate training,
experience and skills. Below you will find a list of basic requirements:
Operators / Trainees / Apprentices:

may be male or female

must be aged 14 or over

must have full use of both hands

must have no physical or mental disabilities

must know and fully understand the contents of the user manual.
EN

SAFETY INSTRUCTIONS

READ AND KEEP THIS MANUAL
17