Kinderfeets Tiny Glider Manual Del Usuario página 6

User Manual for the Kinderfeets
Please read the entire manual before using your Kinderfeets Tiny Glider.
Thank you very much!
Is your newly-mobile little one eager to explore the world on wheels? The
Kinderfeets Tiny Glider is a small 4-wheel foot-powered vehicle designed for
young ambitious riders. An included push stick can be used by parents and
adults to help guide children as they get used to the glider's maneuverability,
and EVA airless tires prevent scratches on indoor surfaces. Invite your child to
test their mobility, develop gross motor skills, and strengthen their balance
and coordination, and enjoy bonding with them while using the push stick
to help them ride. Watch as they gain confidence while cruising around and
witness their imagination take flight as they venture through the big world!
Crafted using sustainably-sourced birchwood, water-based paints and
non-toxic finishings, the Kinderfeets Tiny Glider is the ultimate sustainable
push-bike for active toddlers ages 12 months and older.
Note: The Kinderfeets Tiny Glider is a toy. It's designed for a home setting
only and must always be used under adult supervision. Do not use the toy
on a hill, cliff, ledge or busy street. Avoid adverse weather conditions when
playing outdoors (this includes wet weather, windy conditions, damp ground
or extreme hot and cold temperatures).
WARNING! Must be assembled by an adult. Keep small,
loose parts away from children as they are a choking hazard.
Children should be supervised by an adult while playing.
Always wear protective equipment while riding.
Use safely!
Please read these instructions before using your Kinderfeets Tiny Glider.
This is a moving toy. It must be used with care at all times to avoid injury.
• Check the toy for damage or other problems before using for the first
time. Continue checking it regularly for signs of wear, cracking, damage or
defects. Do not allow children to use the toy until an adult has checked that
its parts are correctly assembled and securely fastened, and its structural
integrity has been evaluated and verified.
• Recommended for children ages 12 months and older. However, each
child's development is unique. Common sense should be used to assess
a child's ability to use this toy safely based on their size, motor and
coordination skills.
• Intended for use with children up to 20 kg (44 lb). Children should only use
this toy under the supervision of an adult.
• Must be used in a safe and sensible manner. Apply common sense at all
times. Never use this toy on stairs, near swimming pools, on public roads,
steep hills, unstable surfaces or areas with traffic.
• Keep packaging away from children to avoid injury or suffocation.
• This is a wooden product. Damage may occur if it's dropped or handled
roughly on hard surfaces. Wear and tear is not covered by warranty.
Tiny Glider
®
Assembling your Kinderfeets Tiny Glider
Remove all packaging and check to ensure all parts are included and in good
working condition.
1. Push the steering device (A) through the front of the frame (B).
2. Slide front axle (F) through steering device (A). On each side of the
axle—slide spacer (D) onto axle, followed by a washer (I). Next, attach the
front wheels (C) into position and secure with axle screws (H) using Allen
wrenches (J). Follow the same steps for the rear axle—slide axle (G) through
frame (B), then apply spacers (E) followed by washers (I) on each side. Attach
the rear wheels (C) and secure with axle screws (H) using Allen wrenches (J).
Note: Wheels must be tightened by hand on each side simultaneously using
both Allen wrenches. It is not possible to tighten the axle correctly using only
one Allen wrench. Do not overtighten the screws. Check that the wheels
can still turn freely after the screws have been tightened. If they cannot turn
freely, loosen the individual screws by a quarter turn.
3. Slide washer (P) onto metal pin of steering device (A) followed by the
steering handle (K). Secure with 2 screws (L), tighten with Allen wrench (J).
4. To use the optional push-stick: Connect both sticks (M & N) using pin (Q).
Make sure the screw holes are aligned and secure with screws (H). Tighten
screws by hand with Allen wrench (J).
Precautions: Before using your Kinderfeets Tiny Glider, please check that it
is undamaged, assembled correctly and that all screws and parts are securely
fastened. Check it regularly for signs of wear, cracking, damages or defects.
A damaged, unsafe Kinderfeets Tiny Glider should no longer be used.
Clean your Kinderfeets toy using a mild cleaning agent, clean water and soft
cloth. Store your Kinderfeets toy in a dry place when not in use.
Do not store it in a location where water condensation can build up
overnight (such as in a shed or on a balcony outside); or in an area with high
humidity (such as a bathroom or laundry room with a condensation dryer).
Always store your Kinderfeets toy indoors in a cool, dry, and well-ventilated
location—especially in a tropical or subtropical climate, or any location
subject to high humidity and/or high rainfall.
Limited warranty
Kinderfeets guarantees that its products will be free from manufacturing
defects for one year from the date of purchase. You must submit an
ORIGINAL copy of the proof of purchase for repairs or exchanges.
This warranty and Kinderfeets's obligations are restricted to the repair
or replacement of products with certified defects occurring within
the warranty period. This warranty does not apply to damages caused
by weather (including but not limited to wind, rain, dew, or water
condensation), improper use, accidents, improper storage (including storage
in high humidity areas), and normal wear and tear caused by normal use.
Kinderfeets is not liable for accidents or subsequent damages resulting
directly or indirectly from the use of its products. The purchaser and user
bear all risks associated with using this toy. This includes physical injury
and/or death. Adult supervisors are responsible for ensuring that appropriate
safety measures are taken. Kinderfeets will not be liable for personal injury
or property damage under any circumstances. To use a Kinderfeets product,
you must agree with the above guidelines.
At Kinderfeets, we do our best to ensure the quality of our products.
However, we know no manufacturing process is perfect or defect-free.
To report or return a damaged item, please send an e-mail to
info@kinderfeets.com. Please attach a description of the problem
and a picture, if possible, as this will help us understand the situation.
You will receive further information or a return address so you can send
the toy back to us.
6
EN