Klarstein Bellevin 6 Uno Manual Del Usuario página 15

USE AND OPERATION
Before first Use
• Clean the appliance, and be thorough, especially in the interior (see „Cleaning and
Care").
• In case the interior accessories are not correctly placed, rearrange them as
described in chapter „Product Description".
Tips for Energy Savings
• Try not to open the door too often, especially when the weather is wet and hot.
• Once you open the door, close it as soon as possible.
• Every now and then check if the appliance is sufficiently ventilated (adequate air
circulation around the appliance).
• Set thermostat from higher to lower settings as soon as possible {depends on how
loaded the appliance is ambient temperature etc).
• Before loading the appliance with packages of fresh foods, make sure they are
cooled lo ambient tempera- ture. For hot foods, please cool to room temperature
before placing it in the cooler.
Operation
When the cooler works with full power, the two LEDs on the circuit board will flash.
The red one shows the power input status. The green one shows the output status of
the cooling system. Meanwhile the fan inside the cooler begins to work. When the
door is opened, the light under the temperature adjuster will turn on automa- tically.
The temperature range for cooler is 8°C to 18°C. When the temperature is set on one
certain point and the temperature inside reaches this point, the automatic temperature
control system begins to work and the cooling system goes into linear temperature
keeping status.
Note: Wait 3-5 minutes before restarting if you unplug the cooler. The unit may fail to
operate properly if restarted too quickly.
EN
15