Publicidad
Installation of the filter system
Step 1: Fix the filter head and the filter
1. Paste the assistant label to finish drilling. (Note: Mount the water filter
at least 2 inches higher than the ground for easier filter change.)
2. Install the screw and reserve enough space to hang the filter.
3. Hang the filter system on the screw.
Step 2: Connect the water supply (cold water only)
1. There is an existing mark at the end of the tubing for you to confirm if
the tubing is fully inserted into the fitting.
2. Connect one end of the 1/4" PE tubing to the inlet of the filter head.
Until you reach the mark on the tubing.
3. Shut off the water supply and remove the faucet hose. (Figure 1)
4. Connect the feed water adapter and ensure that the rubber O-ring is
loaded.
• If the angle valve outlet is 3/8", connect it to the water supply and faucet
hose directly.
• If the angle valve outlet is 1/2", you need to remove the above two
fittings before connection. (Figure 2)
Figure 1
Figure 2
3/8" Cold water valve
Step 3: Install the faucet
Note: If there is no hole in your kitchen sink or countertop, you have to drill one (1")or use the hole for the soap
dispenser.
1. Insert the faucet spout into the faucet body.
2. Insert the faucet stem into the hole on the countertop.
Under the sink, slip on other parts in the order shown in
the picture.
3. Firmly insert the quick-connect fitting onto the faucet
stem.
4. Connect one end of the tubing to the quick-connect
fitting of the faucet, then lock the clip. If you want to pull
out the tubing, remove the clip first.
5. Connect the other end to the outlet of the filter head.
6. Push the tubing into the fitting until you reach the mark
on the tubing.
Mark for
full insert
1/2" Cold water valve
Faucet spout
Faucet body
Countertop
Faucet stem
Mounting washer
Nut
Clip
Quick-connect
fitting
Clip
Step 4: Check the leaks and flush the filter
1. In the event of water leakage, turn off the water supply. If the water leakage is occurring at position 1, wrap
Teflon tape on the external thread. If the water leakage is occurring at position 2, 3 or 4, check whether the tubing
is fully inserted into the fittings. If not, insert it again until you reach the mark on the tubing.
2. Flush the filter for 5 minutes before use.
To disconnect
Use your thumb and index finger to press down on the lock sleeve. Use your other hand to pull out the hose from
the fitting.
Note: Please do not pull out the tubing directly, or else it will damage the fitting and cause leakage.
Filter replacement
1. It's recommended to turn off the water supply and turn on
the faucet to release the water pressure.
2. Rotate 1/4 turn to the left to remove the filter.
3. Take out the new filter and remove the protective cap.
4. Rotate 1/4 turn to the right to install the filter. Ensure that
the filter's triangle mark is aligned with the connection mark.
5. Turn on the cold water valve and flush for 5 minutes.
2
Outlet
Inlet
3
4
1
Hot
Cold
Filter system
Press
Pull
Press
Remove the filter
Install the filter
2
Publicidad
