Bayco 651 Manual De Instrucciones

INS-651-12
Operating Instructions for Model 651
13 Watt Fluorescent Light on Retractable Reel
Multiple Patents Pending
Electrical Rating - All models use 125 Volts 60 Hz
CAUTION - TO REDUCE THE RISK OF ELECTRIC SHOCK AND FIRE - PULL PLUG
WHEN SERVICING, OR WHEN RE-LAMPING - USE ONLY 13 WATT OR SMALLER
BULB
CAUTION
DO NOT use this cord reel in explosive atmospheres, near flammable liquids, or where
explosion proof lamps are required.
DO NOT use in the proximity of vehicles or equipment when there is a risk of flammable
liquids coming into contact with the hand lamp
DO NOT immerse in water
DO NOT use in areas where water can accumulate or in rain or mist
CAUTION: Risk of Electric Shock – For Light Duty Dry Location Use Only
GENERAL USE CORD REEL ONLY. NOT FOR HARD USE. FOR INDOOR DRY
LOCATION USE ONLY FOR LIGHT DUTY RESIDENTIAL USE ONLY
WARNING: NOT FOR USE ABOVE HAZARDOUS LOCATIONS
CAUTION: DO NOT USE IN HAZARDOUS LOCATIONS AS REQUIRED BY THE
CANADIAN ELECTRICAL CODE, PART I
IMPORTANT SAFETY INSTRUCTIONS: This product has a polarized plug (one blade is
wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Never use with an extension cord unless the plug can be fully inserted. Do not
attempt to defeat this safety feature.
CAUTION: DO NOT ALLOW THE CORD TO RETRACT BY ITSELF AS DAMAGE OR
INJURY MAY OCCUR FROM EXCESSIVE REWIND SPEED
CAUTION: Drywall will not hold the weight of the reel assembly
CAUTION: Read and understand mounting instructions before attempting installation
and use of this product
Thank you for purchasing this Bayco cord reel. Please read these instructions before
using.
OPERATION

To operate, plug into a 120 Volt 60 Hz grounded outlet.

Pull out desired length of cord. Notice a clicking noise when pulling. Cord will stay at
the desired length during clicking and rewind after a pull past the clicking noise.
Extended length when retracted can be adjusted by sliding plastic ball to desired
position.

Move I-O switch to "I" position. Lamp may flash several times before lighting,
especially in cold weather. Turn off by moving switch to "O" position.
CAUTION: DO NOT ALLOW CORD TO RETRACT BY ITSELF, AS DAMAGE TO
CORD END FITTINGS MAY OCCUR FROM EXCESSIVE REWIND SPEED.
BAYCO • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • www.baycoproducts.com
TO CLEAN OUTSIDE OF UNIT: Unplug the unit before cleaning and dry thoroughly
before re-using. Use a soft cloth with mild detergent. DO NOT use solvents such as
gasoline, turpentine, etc., to clean the unit. NEVER immerse the reel or cord end fittings
(receptacles or lamps) in water.
FEATURES

13 watt fluorescent work light

The cord is 20ft long; with polarized plug.

Mounts on ceiling or wall

Adjustable cord stop.
BULB REPLACEMENT
1. Unplug the light from the outlet.
2. Use fingernail or edge of knife blade to lift out plastic stud in base of lamp holder.
3. Carefully pull tube from handle.
4. Remove lamp from the lamp holder and discard.
5. Insert new lamp in socket in handle. Make sure both lamp contacts on bottom of
lamp are inserted properly into the socket.
6. Slide tube assembly over lamp and insert top of lamp into slot cut in top lamp holder.
Lamp should just penetrate slot in lamp holder.
7. Align hole in tube with hole in handle and install the plastic stud. Press in firmly until
fully seated.
MOUNTING
Ceiling or Wall Installation
1. Select a location within 2 feet of an electrical outlet. The outlet for a garage door
opener is desirable.
2. Drywall will not hold the weight of the reel assembly, so locate a ceiling joist or wall
stud and using the mounting bracket as a template, mark the holes so they are
centered on the ceiling joist or stud.
3. Attach the mounting bracket to the stud using the 2 wood screws provided.
4. Align the holes on the side of the reel with the holes in the side of the mounting
bracket and insert the pin.
5. Place the retaining ring on the pin and twist until the entire ring is through the hole in
the pin. DO NOT operate this reel without the retaining ring in place on the pin.
SAFETY / CARE
 Caution: do not allow the cord to retract by it self as damage or injury may occur from
excessive rewind speed.
 Adjust the cord stop to hold the receptacle at the desired length when the cord is
retracted.
 Before cleaning the reel always unplug from the power source.
 Clean the outside of the cord reel only. Use a soft cloth with mild detergent. Do not
use petroleum based to clean the cord reel. Never immerse the cord reel or
receptacles or work lights in water. Dry thoroughly before attempting to reattach to
power source.
WARRANTY
PRODUCTS COVERED UNDER THIS LIMITED WARRANTY:
This product is warranted to the original purchaser for 1 year and only covers failures due
to defects in materials or workmanship. If this product is used for rental purposes, the
warranty term is reduced to 90 days from the date of purchase.