Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Selecting a Location
Choose a location for the TSV05RPAA (Under-counter
Refrigerator) that provides a clearance of 4 inches. on each
side.
Appropriate electrical power must be available. Locate the
refrigerator within eight feet of the power outlet so that no
extension cord is required. Attach the refrigerator to the
facility's electrical supply as directed by the National Electrical
Code.
Leveling the Unit
This refrigerator must be in level, in order to provide adequate
condensate drainage as well as proper door alignment and
operation. The refrigerator should be in its final operating
location and set so that it is firmly positioned on the floor.
Electrical Connection
Determine the total amount of current presently being used by
other apparatus connected to the circuit that will be used by
this refrigerator. It is critical that this added current demand
and other equipment on this circuit not exceed the rating of
the fuse or circuit breaker in use.
The frequency and nominal voltage requirements for the unit
are specified on the data plate. Supply this unit with an
electrical source that meets these requirements only. Low line
voltage is often the cause of service complaints. With the unit
running, check that the line voltage is within ±10% of that
specified on the data plate.
CAUTION: Be sure the voltage supplied to the
refrigerator is equal to that specified on the data
plate.
WARNING: For personal safety, this unit must
be properly grounded before use.
ADA Undercounter Laboratory Refrigerator
Unit must be connected to a grounded outlet matching the
nameplate and / or the information furnished in this manual. If
you are not sure about the outlet, you should contact a
qualified electrician for assistance.
The Unit should always be connected to a dedicated power
source.
WARNING: DO NOT REMOVE, under any
circumstance, the grounding prongs from the
3-prong power cord supplied with all units.
WARNING: DO NOT USE electrical extension
cords, it may result in voltage loss and possible
hazardous operation.
Reversing the Door Swing
1. Unscrew the lower hinge and take off the door.
2. Push the kick plate to the right in the new position.
3. Undo the upper hinge fastener and fix it to the opposite
side of the housing, where you have already removed
and replaced the fastener with the hole to the opposite
side.
4. Put the door on the upper hinge fastener.
5. Fix the lower hinge in the new position.
6. Unscrew the handle and place it on the opposite side.
7. Some screws are covered with caps. Take off these caps
before undoing the screws.
8. Check the door gasket. It should not be creased and
should seal well.
Installation |
7
Publicidad
