Publicidad
Idiomas disponibles
Idiomas disponibles
User Guide
1. WARNINGS
General Precautions
When not in operation detach the power cable from the mains supply.
Also, remove the safety key from the front panel.
The precautions also apply before leaving the High Voltage Unit unattended.
Before usage User Guide must be read and e-Learning must be completed!
ELECTRICAL HAZARD
10 kV~ / 400 V⎓
The DEVItector™ II V2 is a high voltage unit outputs
up to 10000 V~/ 400 V⎓!
This equipment must only be used by authorised
and instructed personal!
Do NOT leave the unit unattended!
Incorrect use can be fatal!
Besides the operator, all other persons must be kept
out of the working range. This also includes animals.
Preferably, the working range is marked by visible
markers, i.e. yellow tape.
Unplug all other equipment from the wall outlets to
disarm the risk of the high voltage cable terminals
touching a wire within the thermostat wall box.
When the burning is activated, DO NOT touch the high
voltage cables as neither the RCD relay or the high
voltage unit will disconnect in case of a faulty current.
The user must be aware that, if the equipment is
used in a manner not specified by the manufacturer,
the protection provided by the equipment may be
impaired.
Warning against operation when wet or in wet
conditions.
IP class of each part of DEVItector™ ll V2 is 20.
IP First number – protection against solid objects,
2 – protected against solid objects up to 12 mm, e.g.
person fingers. IP Second number – protection
against liquids, 0 – no protection.
WARNING
Take special care considering heavy weight.
BC421332622232es-ES0101
DEVItector™ II V2
17 kg
ELECTROMAGNETIC HAZARD
The High Voltage Unit can cause radio noise or
electromagnetic radiation, so pay attention to time
and place and inform people nearby!
Take special care when working at or near
hospitals to avoid disturbing medical equipment.
DEVItector™ should not be operated by people
with pacemaker or weak heart.
FIRE HAZARD
If the heating cables are not completely covered by
non-flammable materials such as sand or concrete,
and close to flammable material, cable burning
procedure should be undertaken with great
caution as the heating cable will burst into open
flames at the fault location.
Danfoss A/S doesn't take responsibility for burned
property.
RESTRICTION OF USE
The equipment must only be used on electrical
heating cables while these cables and their
accessories are disconnected from the mains
supply and from building installation.
The user must be aware that, if the equipment is
used in a manner not specified by manufacturer,
the protection provided by the equipment may be
impaired.
2022.07 | FEC | ©Danfoss | 3
Publicidad
