Publicidad
Idiomas disponibles
Idiomas disponibles
Setting the Time
– To set the time, press the
hours indication flashes in display element e.
– Press the
seek button 12 or the
ton 11 until the correct hour setting is indicated.
– Press the
button 10 again, so that the minutes
indication flashes in display element e.
– Press the
seek button 12 or the
ton 11 until the correct minute setting is indicat-
ed.
– Press the
button 10 a third time to store the
time setting.
Working Advice
Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water.
Store the battery only within a temperature range
between –20 °C and 50 °C. As an example, do
not leave the battery in the car in summer.
A battery that is new or has not been used for a
longer period does not develop its full capacity un-
til after approx. 5 charging/discharging cycles.
A significantly reduced working period after charg-
ing indicates that the battery is used and must be
replaced.
Observe the notes for disposal.
Troubleshooting – Causes and
Corrective Measures
Cause
Construction site radio inoperative
No power supply
Construction site radio
too warm or too cold
28 | English
button 10 until the
seek but-
seek but-
Corrective Measure
Completely insert the
power-supply plug and
plug-in connector or the
charged battery pack
Wait until the construc-
tion site radio has
reached operating tem-
perature
Cause
Construction site radio inoperative on
AC power supply
Power-supply plug
or connection cable
defective
Wrong power-supply
plug inserted
Construction site radio inoperative
on DC power supply
Battery contacts con-
taminated
Battery pack defective Replace the battery
Battery pack too warm
or too cold
Construction site radio suddenly inoperative
Power-supply plug or
battery pack not prop-
erly or completely in-
serted
Bad radio reception
Interference from oth-
er devices or insuffi-
cient set-up location
Time indication faulty
Back-up batteries of
clock empty
Back-up batteries in-
correctly inserted
(wrong polarity)
When the corrective measures do not eliminate an
error, please contact an authorised service agent
for BTI power tools.
Corrective Measure
Check the power-supply
plug and the connection
cable, and have them re-
placed as required
Use the original BTI pow-
er-supply plug (also avail-
able as spare part)
Clean the battery con-
tacts (e.g. by inserting
and removing the battery
several times) or replace
the battery
Wait until the battery has
reached operating tem-
perature
Plug in power-supply
plug or battery properly
and completely
Position the construction
site radio at another loca-
tion with better reception
or with greater clearance
to other electronic devices
Replace back-up batteries
Insert back-up batteries
correctly
1 609 92A 0YY • 4.11.14
Publicidad
