TRAMPOLINE & ENCLOSURE ASSEMBLY
WARNING:
!
CHOKING HAZARD - Small Parts
Not for children under 3 yrs.
1
Begin by assembling 2 of the top rails
together into an arc.
4
With the top rail frame connected into a circle, lay it flat
on the floor (either side facing up - they are identical).
Then insert the tapered end of each of the 6 leg tubes
into the 6 leg sockets that are facing up, as shown. The
Curves should all point out - away from the center of
the trampoline.
6
After attaching all 6 of the legs securely to the top
rail frame, turn the frame over so that the legs
point downward, as shown.
Refer to PARTS LIST for identification of parts.
WARNING:
!
ADULT ASSEMBLY REQUIRED
Contains small parts, sharp points and sharp edges.
2
Continue building a circle by adding the
remaining 4 top rails to the arc you made
in Step 1.
-5-
3
Joining the 2 loose ends of the circle together
may require you to stand the frame on edge
and press downward on the 2 ends, while
connecting them together.
5
Align the screw hole in the leg with the hole in the leg
socket. Then secure with screw and tighten. DO NOT
OVER-TIGHTEN. Repeat this until all 6 legs are securely
attached to the top rail frame with screws.