Publicidad
Set the switch at the desired
speed.
SAWING AND NAILS SHAPING
DISCS
Discs (A, B) are designed for shaping and sawing thick and thick nails. Use the nozzle that is most suitable for the thickness of your
Nozzle A - Disk for sawing and nails shape (less rough)
Nozzle B
–
Disk for sawing and nails shape
DISC FOR POLISHING
Used to give a smooth and rounded nails after they are processed, and for polishing the surface of the nail at the end of the manicure / pedicure.
DISCS TO REMOVE ROUGH SKIN
Discs (C, D) are designed to remove rough skin from the feet and in places where there are rough areas of
Gently push the said nozzle to areas of rough skin on the feet, heels and treat these places, moving the device forward and
BIG CONE NOZZLE
Designed for resurfacing of the skin on the soles and heels and remove rough skin around the nail plates on the toes and
SMALL CYLINDRICAL NOZZLE
Designed to remove rough skin around the nail plates and treatment of ingrown nails on the toes. Use, using the movement from the outside of the nail
ROUND BRUSH TO CLEAN NAILS AFTER TREATMENT
Designed for cleaning nails after manicure / pedicure or to prepare nails for
RECOMMENDATIONS
For the best effect in nail care not to steam arms and legs before the procedure, do it after a manicure / pedicure.
After the manicure is recommended to immerse the hands in warm, soapy water and then process them in any moisturizer or lotion. This will prevent nails from drying and keep them healthy.
CLEAN AND CARE
Unplug the appliance from electrical supply network and wait until it completely completely cooled down.
Wipe over the housing, using a slightly damp cloth. Do not use any abrasive materials
Do not allow water or other liquids into the appliance.
(more rough)
polishing.
nails.
skin.
back.
calluses.
8
inside.
Publicidad
