Bimar Goya ND18D2P Folleto De Instrucciones página 14

INSTALLATION
 After removing the packing materials, check the integrity of the heater; if you are
unsure, do not use it and ask for qualified professional help. The packing materials
(plastic bags, polystyrene foam, nails, etc.) must be kept out the reach of children
because they are potential sources of danger.
 Before connecting the appliance, check that the voltage shown on the data plate
matches that of your electricity and that the electric plug is grounded. In the event
of incompatibility between the electric outlet and the plug of the heater, have the
outlet replaced with another more suitable type by professionally qualified
personnel, who will make sure that the section of the wires of the outlet is
appropriate for the absorbed power of the heater (10A). In general, the use of
adapters or extension cords is not recommended; if their use is indispensable, they
must conform to existing safety standards and their current capacity (amperes)
must not be less that the maximum of the heater.
 Before each use, verify that the heater is in good condition and that the electrical
cord is not damaged: in the case of doubt, ask for professionally qualified help.
 Don't hang it on the wall.
 Make sure that the cable is correctly positioned and that it is not in contact with hot
parts or sharp edges, nor wrapped around the device or twisted.
 The power socket must be easy to reach so the plug can be removed quickly in case
of emergency.
 Position the fan heater far from other sources of heat,
inflammable materials (curtains, carpets, etc.), inflammable
gases or explosive materials (spray cans) and from materials
that can deform on exposure to heat. Make sure that there
is 120 cm of free space in front of the fan heater and 150
cm on the sides.
 Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool. (to avoid drops of water falling on the heater or the heater falling in
the water), or in places where it could be subject to shocks.
 The support surface must be stable (exclude shelf) and not sloping (since the heater
could tip over).
 Make sure that the air-intake grids and heating element are not obstructed by
objects, fabrics or anything else to avoid the heater overheating or breaking.
 In the case of a breakdown or fault, switch off the appliance and have it checked by
a professionally qualified technician; repairs made by unqualified persons can be
dangerous and render void the warranty.
OPERATION
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer or a
competent qualified electrician or a person with similar qualifications, in order to
avoid any risk.
ATTENTION: The heater should not be used if the glass or other parts are damaged.
For the use of a chimney, operates in the following way:
1. Insert the plug into the socket.
2. Open the drawer of the controls.
14/36