Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance and Service of your ES series Fridge-freezer
All laboratory fridge-freezers feature automatic defrosting of the fridge and, in normal
conditions, means that no manual defrosting is required. However, in certain conditions (e.g.
when the fridge-freezer is very full or when any new items are stored in the fridge-freezer)
frost may form on the rear wall as the compressor must run for long periods of time. As
automatic defrosting takes place while the compressor is not running the fridge-freezer may not
defrost completely before the compressor restarts. In these instances some manual defrosting
may be required.
Before manually defrosting the cabinet, make sure the power lead is disconnected from the
mains. Any loose frost found on the evaporator can be removed carefully using a wooden or
plastic scrapper.
WARNING: Do not use any knives or sharp metallic objects to remove frost.
The freezer requires manual defrosting; before manually defrosting the cabinet, make sure the
power lead is disconnected from the mains. Any loose frost found on the evaporator can be
removed carefully using a wooden or plastic scrapper.
Alternatively a non-scheduled defrost can sometimes be carried out as follows:
Function
To carry out a non‐scheduled defrost
N.B. This does not replace the automatic defrost function on relevant models
Defrosting
Press
followed by
followed by
followed by
Hold button(s)
Example screen
down for
3 seconds
Four times
1 second
1 second
11
Publicidad
