Descargar Imprimir esta página

Envirolite T8 Instrucciones De Instalación página 2

Tira led industrial blanca de 8 pies lámpara con 4 tubos de led

Publicidad

Idiomas disponibles

Idiomas disponibles

__________
ASSEMBLY
1.
Remove the channel cover on each side
of the fixture body by twisting metal
retainer clips and gently pulling them
out (Fig. 1, Part A).
2.
Remove the end caps from the channel.
Remove the 4 T8 lamps and put them
aside in a safe place.
3.
Install the lamp holders with black and
white wires in the bracket in the middle
of the fixture. Install the 4 other lamp
holders without wires in the two end cap
bracket slots. Re-install the two end
caps on the end of the channel. (Fig. 2)
____________________________
CEILING MOUNT INSTALLATION
1.
Combine both sides of the J-box cover
until you hear a click, screw onto ceiling
outlet box.
2.
Mark the location of each of the four
mounting holes from the fixture body onto
the ceiling, then attach an anchor (not
included) to each of these locations (Fig.
3).
3.
Mount the fixture to the ceiling with the
mounting screws (not provided) (Fig. 3).
Fig. 1
Part A
Part B
Fig. 2
Fig. 3
_____________________________
HANGING MOUNT INSTALLATION
1.
Punch out the knockout holes in the
corners of the fixture body.
2.
Insert an S-Hook (not included) into
each hole on the end of the fixture.
3.
Attach a chain (not included) to
each S-Hook, then attach each
chain to the ceiling via your
preferred mounting option (Fig. 4)
NOTE: Due to safety regulations, the
fixture and supply wires should not be
left exposed when hanging from the
ceiling. For up-to-code wiring options,
choose from one of the following two
steps (hardware not provided).
__________________________
WIRING WITH CONDUIT WHIP
NOTE: Use either a square or an
octagonal outlet box cover depending
on the shape of your outlet box.
1.
Connect the fixture wires to the
wires at one end of the whip using
wire nuts. Tuck the connections
inside the fixture. (Fig. 5)
2.
Attach the fitting at the end of the
whip to the knockout hole (C). (Fig.
5)
3.
Attach the outlet box cover to the
fitting at the opposite end of the
whip. (Fig. 5)
4.
Connect the supply wires to the remaining wires on the whip. Tuck the connections into
the outlet box. (Fig. 5)
5.
Mount the outlet box cover to the outlet box using mounting screws. (Fig. 5)
Fig. 4
Fig. 5
2

Publicidad

loading

Productos relacionados para Envirolite T8