Trust START-LINE AWST-8802 Manual Del Usuario página 4

EN
AWST-8802 DOUBLE WIRELESS WALL SWITCH
1. Open wall switch
A
Open the wall switch with a screwdriver.
2. Learn code to Trust Smart Home receiver
To control 1 or several receivers simultaneously, assign the
transmitter code to 1 or more receivers. Read the receiver's
manual for the code learning procedure. Send an ON-signal
by pressing the [ON] button while the learn mode is active.
3. Affix the transmitter using screws
A
Use a flathead screwdriver to remove the button first.
B
Then place the flat screwdriver in the recess of the
frame and lift the screwdriver to unclip the frame from
the back plate.
C
Screw the backplate to a location with a flat surface
(make sure the arrow on the back plate points up). First
click the frame back onto the backplate and then the
push button.
4. Affix the transmitter using double-sided tape
A
Apply double-sided tape to the back of the wireless
switch.
B
Stick the wireless wall switch onto a flat surface, e.g.
a wall.
5. Control 1 or multiple Trust Smart Home
receivers
You can assign the AWST-8802 to one receiver or you can
assign the AWST-8802 to multiple receivers, to control
them simultaneously. Read the receivers manual for the
code learning procedure.
4
6. Manual operation of a Trust Smart Home on/
off receiver
A
Press ON once to switch the receiver on.
B
Press OFF to switch the receiver off.
7. Manual operation of a Trust Smart Home
dimmer receiver
A
Press ON once to switch the receiver on.
B
Press ON again to activate the dim-mode. The light will
slowly dim up and down.
C
Press ON a third time to select the desired light
intensity.
D
Press OFF to switch the receiver off.
8. Manual operation of a Trust Smart Home
electric screens receiver
A
Send an ON-signal to raise the screen.
B
Send an ON-signal again to stop.
C
Send an OFF-signal to lower the screen.
D
Send an OFF-signal again to stop.
Read the receivers manual to reverse the direction of the
screen, if needed.
9. Replace transmitter battery
A
Use a flathead screwdriver to remove the button first.
B
Then place the flat screwdriver in the recess of the
frame and lift the screwdriver to unclip the frame from
the back plate.
C
Remove the battery by inserting the flat screwdriver
into the slot and sliding the battery out.
Insert a new CR2032 battery. Make sure the + side is facing
up. The wireless wall switch is now ready for use again.
1. Öffn
A
Öffn
2. Trai
Zum gl
Empfän
mehrer
Codes e
Empfän
Taste [O
3. Bef
A
Entf
Schl
B
Stec
im R
Rück
C
Schr
Pfei
Sie z
Rück
4. Bef
Klebe
A
Kleb
Funk
B
Kleb
Obe
5. Eine
Den AW
mehrer
Verfahr
Gebrau
6. Han