Publicidad
Idiomas disponibles
Idiomas disponibles
• All piping parts are BSP ½"
Wind some white tape at the
thread
sector of the inlet pipe
(marked blue).
• Fix the safety valve to the inlet
pipe and then connect it to the
coid water pipe of the mains.
• InstaII a water drainpipe to the
safety valve to drain away water
discharge. (drain pipejoint out-
let-diagram 5)
Diagram 5
PIPE CONNECTION
• Install the drainpipe in a conti-
nuously downward direction and
in a frost free environment.
• Connect the hot water pipe
(marked red) to the outlet pipe.
• Do not over-tighten the safety
valve and all pipes joint as it may
cause damageto the joints.
• Make sure all pipes are clean
before installing the taps and
showers.
05
Publicidad
