Publicidad
Idiomas disponibles
Idiomas disponibles
GB
STORAGE OF YOUR H-PURIFIER
1.
Switch off the Air Purifier and unplug the socket.
2.
Clean all internal & external surfaces of the Air Purifier and the external mesh of the Filter.
3.
Remove the bottle from the diffuser. Refit the original cap onto the bottle and store it to protect from direct light. Clean the surfaces of diffuser
unit and Diffuser Cover. Make sure there is no residual of H-Essence on any surface of the Air Purifier.
4.
Ensure all components are dry.
5.
Remove the Air Inlet Cover [Fig. 17a] and Reel in the power cord by pulling on the cord [Fig. 17b] and fit the cord into the storage hook and
fit the plug into the transport location. [Fig. 17c,d] Refit the air inlet cover [Fig. 17e]
6.
Store the Air Purifier in a cool dry place.
Fig. 17
ALERTS & SOLUTIONS
The following codes may appear during use. [Fig. 18]
Fig. 18
Error Description
Outer Layer's Filter
cleaning Alert
Filter replacement
Alert
Filter not present or
filter has not been
locked
Dust sensor
malfunctioning: no
signal from sensor or
output voltage exceeds
the limit value
Motor no speed
CO sensor
malfunctioning
ATTENTION: If any of these failures persist, contact your local Hoover representative. DO NOT try to disassemble the H-Purifier by yourself.
12
REPLACE
FILTER
Error Description
Alert on product Control
Panel / Display
Alert of "CLEAN FILTER" blinks
on display
Alert of "REPLACE FILTER"
blinks on display
Alert of "FILTER MISSING"
blinks on display
/
/
CO sensor status lamp is on in
yellow
Alert on APP
1.Follow the instructions in I/M to clean the Outer
Filter cleaning Alert
Layer's Filter.
2.Reset the alert.
1.Follow the guidence in I/M to replace the filter.
Filter replacement Alert
2.Reset the alert.
1.If filter is not present, put it back.
Filter not present or filter has
2.If filter is in position, check whether the Filter
not been locked
Tab has been switched to LOCK status.
Dust sensor malfunctioning: no
Dust sensor failure or dust sensor wire has not
signal from sensor or output
been connected well, please call service center
voltage exceeds the limit value
to fix.
Motor failure or motor wire has not been
Motor no speed feedback
connected well, please call service center to fix.
CO sensor malfunctioning
Alert: need call service.
Error Solution
Publicidad
