Publicidad
Idiomas disponibles
Idiomas disponibles
Log Splitter, 4000 kg
INTRODUCTION
To get the most out of your new product, please read this manual before use. Please
also save the manual in case you need to refer to it at a later date.
TECHNICAL DATA
Size: 109x40x64cm
Power: 230V/50Hz/1500W
Max splitting force: 4000kg
Max cutting diameter: 21cm
Max cutting length: 37cm
Working height: 45cm
Hydraulic pressure: 16Mpa
Protection degree: IP54
Incl. 2 wheels
Safety net around splitting head
Cable length: 200cm
The diameter of the log is indicative – a
small log can be difficult to split when it
has knobs or a particularly tough fiber.
On the other hand, it may not be difficult
to split logs with regular fibers even if
its diameter exceeds the max. figure
indicated above.
This is a Category 1 product, with the
earthing protection provided via the
Schuko plug.
A 16A fuse should be used.
APPLICATION CONDITIONS
This log splitter is a home use model. It
is designed for operating under ambient
temperatures between +5°C and 40°C
and for installation at altitudes no more
than 1000m above M.S.L. The surrounding
humidity should less than 50% at 40°C.
It can be stored or transported under
ambient temperatures between -25°C
and 55°C.
SAFETY WARNINGS & CAUTIONS
Understand your log splitter
Read and understand the owner's manual
and labels affixed to the log splitter. Learn
its application and limitations as well as the
specific potential hazards peculiar to it.
Drugs, alcohol and medication
Do not operate the log splitter while
under the influence of drugs, alcohol, or
any medication that could affect your
ability to use it properly.
Avoid dangerous conditions
The splitter tunnel must be fitted for
safety purposes. See "Fitting the splitter
tunnel".
Bolt the log splitter to the work surface if
it tends to slip, walk, or slide.
Keep your work area clean and well
lighted. Cluttered areas invites injuries.
Do not use the log splitter in wet or damp
areas or expose it to rain.
Do not use it in areas where fumes from
paint, solvents or flammable liquids pose
a potential hazard.
Inspect your log splitter
Check your log splitter before turning it
on. Keep guards in place and in working
order. Form a habit of checking to see
that keys and adjusting wrenches are
removed from tool area before turning it
on. Replace damaged, missing or failed
parts before using it.
Dress properly
Do not wear loose clothing, gloves,
neckties or jewelry (rings, wrist watches).
They can be caught in moving parts.
Protective electrically non conductive
gloves and non-skid footwear are
recommended when working. Wear
protective hair covering to contain long
hair, preventing it from getting caught in
machinery.
Protect your eyes and face
Any log splitter may throw foreign objects
43
GB
Publicidad
