Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
ON/OFF (I/ ) Power Switch
• Plug into outlet.
• Turn switch ON (I).
• Interlock lid indicator light will be flashing.
• When jar and lid are in place, light will stop flashing.
• Select LOW, MED, or HIGH and then press START.
OR
• Select START and PULSE.
• When desired consistency is reached, press STOP.
Troubleshooting Guide
Blender fails to start or stops while it is running and cannot be restarted.
• Check to see if unit is securely plugged into an electric outlet.
• Check to see if the fuse for the electric outlet has blown or if a circuit breaker on the unit has tripped.
• Check control panel for flashing interlock lid light. Realign lid. Start blending.
• The motor is overheated. Try mixing smaller batches or running for shorter cycle times. Allow motor to cool
between batches.
• The blender will automatically stop after 3 minutes.
Ingredients will not mix properly.
• Check to see if enough liquid has been added to the ingredients. Mixture should be fluid and free-running at
all times.
• Solid pieces are too large. Cut pieces smaller.
• Inspect container and cutter assembly daily. Replace container and cutter assembly if damaged.
• Check to see if cutter assembly is installed properly.
• Select speed to create a fluid blend.
Maintenance
Inspect the blender and its various parts and replace as follows:
Daily
Unplug the blender, remove the container from the base, and then inspect the container and cutter
assembly for wear, stress cracks, or loose blades. If the blades are nicked, broken, or loose, discontinue use
immediately and replace the container or cutter assembly. See "Replacement Parts" on website
www.hamiltonbeachcommercial.com.
Weekly
Unplug the blender, and then inspect the power cord insulation and power plug for damage. Refer to
"Technical Services" for repair or replacement. Remove jar from blender base. Inspect the cutter assembly
by rotating the drive end of the cutter assembly by hand. It should turn smoothly. If it does not, replace the
container and/or cutter assembly.
7
Publicidad
