Canyon CNS-TWS6B Guia De Inicio Rapido página 15

Pairing the earphones with the device (Fig. H). Place the case with the
earphones and the device within 90 cm of each other. Remove the earphones
from the charging case. The connection between the earphones will be
established automatically, and a short tone will sound. Flashing red and blue
LEDs (10) indicate that the earphones are ready for pairing with the device.
Turn on the BT devices, go to the BT settings and select the "Canyon TWS6"
earphones. If the pairing is successful, you will hear a tone.
Control when listening to audio recordings (Fig. I, J). Select a track on
your device. Play/pause: press the touch button (9) on either earphone twice.
Skip: press the touch button (9) on the right (skip to next track) or left (skip to
previous track) earphone three times.
Control with an incoming call (Fig. I, J). When there is an incoming call, to
answer or end the call, press the touch button (9) on either earphone twice.
To reject an incoming call: press and hold the button (9) of either earphone for
2 seconds.
Call the voice assistant (Fig. I). Press and hold the touch button (9) of the
left earphone for 2 seconds.
15