sylvac ISP091201D Instrucciones De Uso página 14

8. Switching off
E
The dial gauge goes automatically into stand-by if not used for 20 minutes, unless automatic switch-off mode has been
turned off (see Chap. 4, advanced functions)
SET
Stand-by mode can be forced by a prolonged press (> 2 sec) on :
SET
>2s
In stand-by mode, the value of the origin is retained by the sensor (SIS mode), and the instrument automatically restarts
with any movement of the measurement probe, RS command, Bluetooth® request or press a button.
The instrument can be switched off completely for a long period of non-use, but this will necessitate a zero reset on restart
(the origin will be lost) :
SET
- Prolonged press (>4 sec) on :
SET
>4s
9. Re-initialising the instrument
The initial instrument settings can be restored at any time by a prolonged press (>4 sec) simultaneously on and
MODE SET
until the message rESEt is displayed.
14