Publicidad
EN
Attaching the display unit
The display unit can be attached to the aluminium mounting block
using a holder.
If you prefer not to attach the display unit directly to the mounting
block, it can be held in the stand. This might be necessary if, for
example, the indicating torque wrench is a long-handled one, see
„Fixing the display unit on the stand" on page 36.
Attaching the display unit to the mounting block
Release the clamping screw. To do so, turn the clamping
screw anticlockwise.
Insert the pin of the holder all the way into the hole.
Inserting the holder in the hole
32
Publicidad
