Before First Use; Operation - Unold White Line 38641 Instrucciones De Uso

25. The surface of the cover may become hot
during operation. Therefore always use the
handles of the cover.
26. Do not move the appliance as long as it
is in operation, to prevent scalding from
splashing water.
27. Do not use the appliance with accessories
of other manufacturers or brands, to prevent
damage.
28. Disconnect the appliance from the wall
socket after use and prior to cleaning. Never
leave the appliance unattended when it is
connected to the wall socket.
29. Let the appliance cool off before cleaning it.
30. Never open the casing of the apppliance.
There is danger of electric shock.
the manufacturer will not be liable in the event of incorrect assembly, improper or incorrect use or if
repairs are carried out by unauthorized third parties.

BEfORE fIRSt USE

1. Remove all packaging materials and any
transport safety devices.
2. Clean all parts with a damp cloth, as
described in the chapter "Cleaning and
care" on page 11.

OPERatION

1. Fill the cup with cold water subject to the
desired hardness and the number of eggs:
ƒ hard
ƒ medium
ƒ soft
please use the respective marks at the cup.
Pour the water into the water tray. The marks
apply to medium egg sizes. Depending on
the size, number and freshness of the eggs,
the results may slightly differ.
2. Pierce the blunt end of the eggs with an egg
piercer. This is important to avoid that the
eggs burst during cooking.
atteNtIoN.
risk of injuries by the egg piercer!
3. Place the eggs on the egg holder. Place the
egg holder with the eggs on the water tray
and close the lid.
4. Put the plug into the receptacle and switch
on by pushing the ON/OFF switch. The
control light is turning on.
5. When eggs are ready, the buzzer sounds.
10
31. Check the appliance, the wall socket and
the lead cable regularly for wear or damage.
In case the lead cable or other parts appear
damaged, please send the appliance or the
base to our after sales service for inspection
and repair (for address, see warranty terms).
Unauthorised repairs can constitute serious
risks for the user and void the warranty.
32. If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order
to avoid a hazard.
3. Connect the base to the mains supply by
means of the lead cable (230 V~, 50 Hz).
4. Check if the appliance is placed firmly.
6. If you want to serve the eggs immediately,
switch off the appliance. If you want to
kept the eggs warm, leave the appliance in
ON-position until you finally take out the
eggs.
7. If the appliance is switched off, the control
lamp turns out. Remove the lid.
attention:
take care of escaping hot steam!
since the lid is very hot, use the handle
to lift off the lid or use oven cloths and
place it only on heat-resisting surfaces!
8. Remove the egg holder with the eggs from
the water tray and hold them under cold
water. If the boiling process is not stopped
immediately after the buzzer signal is heard,
eggs will continue to boil and become
harder. You may now serve the eggs.
9. After a short cool-down time of approx.
5 minutes you may use the egg boiler
again.
10. Unplug the appliance after use.