Publicidad
Idiomas disponibles
Idiomas disponibles
GETTING STARTED
Before installing Pulsar Plus
Before installing your charger, be sure to obtain any required permits and/or approvals in
accordance with applicable codes, regulations, and ordinances for electrical installations.
Wallbox Chargers S.L.U.
PN:XXXX-X-X-X-X-XXX-X
----
Plug-in Version
Cable length
12" (30 cm)
Outlet height
Recommended
43-59 "
(110-150 cm)
E506750 EVSE
Hardwire Version
Charger height
Recommended
50-67 "
(130-170 cm)
Prepare the charger for
installation
Before getting started, carefully lift the charger
from the packaging, remove the cardboard
covering the cables, and carefully unfasten the
plastic cable ties on the EV cable bundle. Leave
the cables in the box until needed to ensure they
do not get damaged during installation.
Check the product label to identify the model/
version of your charger. Make note of the serial
number (SN) and unique identification number
(UID) as you will need these to complete the
registration of your charger.
Location
For the placement of your charger, consider
how you will normally park your car, the
location of the vehicle's charge port, and the
length of the charging cable (25 feet/750cm).
NOTE: You should always have enough
slack in the charging cable so as not to apply
tension to the cable or the cable connections.
For secure mounting, you will want to install
your charger on a vertical wall stud or on a
solid wall with appropriate mounting anchors.
Positioning
We recommend installing your charger as
shown in the diagram on the left. Note that the
minimum installation height must be at least
18" (46cm), measured from the bottom of your
charger. Wallbox recommends an installation
height of 50-67" (130-170cm).
With NEMA cable installations, be sure to take
into consideration the 12" (30cm) length of
NEMA cable when positioning your charger in
relation to the NEMA receptacle.
For hardwire installations, the wiring may use
either the rear or bottom access ports in your
charger. Be sure to note that the power supply
wiring and conduit (if used) will need to be
placed on the left side of your charger.
40A NEMA Plug-in installation: page 11.
40A or 48A Hardwire installation: page 14.
EN
11
Publicidad
