3B SCIENTIFIC PHYSICS U15300 Instrucciones De Uso página 7

•
Loosen Phillips-head screws and retension the
rubber belt by moving the bracket for the deflec-
tion pulley.
•
Retighten the screws and mount the metal
sphere.
•
Align the metal edge as shown in Fig. 2.
4
5
3
Fig. 2 Retensioning the rubber belt (1 Rubber belt, 2 De-
flection pulley, 3 Phillips-head screws, 4 Bracket for deflec-
tion pulley, 5 Top metal edge)
7. Storage and maintenance
•
Clean the van de Graaff generator with warm
water and some dish washing liquid and dry it
thoroughly (with a hair dryer). Never use sol-
vents.
•
In case the generator is not in use for a longer
period of time, remove the rubber belt and store
it in a dark place.
•
Store the Van de Graaff generator at a dry place
and always cover it with the dust cover. Do not
expose the generator to direct heat sources (sun,
radiator).
3B Scientific GmbH • Rudorffweg 8 • 21031 Hamburg • Germany •
3
2
1
Subject to technical amendments
© Copyright 2009 3B Scientific GmbH
www.3bscientific.com