OZU WELL-BEING Serie Manual De Instrucciones página 28

5.2 Get started
-
Tear o the protective lms on electrode patches, then paste the electrode
patches onto body parts in need of stimulation, including "shoulders, back, arms,
legs, feet and joints (as shown below), not applicable to heart and upper back.
Push the switch from OFF to ON to start up the device. It's recommended to use
the device twice a day, 15min each time.
Joints
Feets
Attention:
1) The electrode patch can be used for about 80 times (15min each time).
When its viscidity can't be restored even after being cleaned for many times,
please purchase new electrode patch from retailer or manufacturer.
2) Only use electrode patches equipped with the product. The size of
electrode patch is about 55mm (width)*79mm (height)* 2.2mm (thickness).
Please do not use electrode patch of other size.
3) Do not dispose the electrode patch casually. Please follow the local
environmental requirements.
4) Make sure the connection between electrode patch and host is good, or
else it might a ect the function of the product.
5) One pair of electrode patches can only be used by one person.
5.3 Usage method of the host
-
1.It has two separate channels which could work individually or
simultaneously.Each channel is programmed with 6 modes (12 modes in total)
and 16-degree intensity.
2.Tear the protective lm of electrode patches, stick them onto sore parts
(Ashi points), keep relax, hold the host and turn "ON/OFF" to start.
3.After starting up, the default channel is framed"CH1"and timing 15 minutes.
Press" " to change the mode while "+""-"buttons to adjust the intensity.
Press "CH"to start CH2 channel,then"CH2" on LCD screen is framed. Activate
2
1
3
5 5
4
6 6
EN - 9
2
1
3
4
Soulders
Arms
Back
Legs