Getting Started
Please make sure that you read all of the information contained
within this user guide before contacting the customer helpline.
If you experience any problems, please check the Troubleshooting
guide at the back of this user guide before contacting the customer
helpline.
The Li-ion battery contained in this unit must be recycled or
disposed of properly. Do not dispose of in household waste or burn.
Charging the Battery
Before using yourdevice the battery will need to be charged. To
maximize the life of the battery the first charge must fully charge
the battery. We recommend that you charge the unit for 5 hours in
order to achieve the full charge. Subsequent charge times may be
shorter. Plug the mains adapter into the socket on the rear of the unit
marked 5V.
Plug the adapter into the mains supply and switch it on.
The red LED indicator on the front panel to connect an external
power supply. When the device is completely recharges the process
will be will signal icon in the upper right corner of the display.
We recommend that when you use navigation in your car, that
you always use the 12V cigarette adapter in order to maintain the
battery level.
Installing the micro SD Memory Card (Optional)
Once the card is installed it does not need to be removed. If you
need to remove the card, switch the unit off first, push the card in
and it will eject from the slot.
When re-installing it can only be fitted one way - contacts towards
you and the cut-off corner at the top as shown. Slide the card in and
push fully home so that it clicks in place.
It can support up to 8GB micro SD card.
EN
PL
13