DeWalt DWMT70777 Manual De Instrucciones página 6

FEATURES
SPraY Gun BoDY
The body of the spray gun is designed to be well-balanced
and lightweight. The spray gun body is a pro-grade high
volume low pressure (HVLP) design.
SPraY Gun cuP
The cup (a) of the spray gun can hold
600 mL (20 oz) and has a removable
snap in lid (K). The design of the spray
gun cup lid (K) includes an accessible
tab for easy removal from the
spray gun cup (a).
MaTerIaL FILTer
The material filter (B) is used to protect
against contaminants and small particles.
It is located inside of the spray gun,
between the spray gun cup (a) and air cap (c).
aIr caP HornS
The position of the air cap (c) horns
(D) allow two spray patterns.
See Fig. 2.
aIr VoLuMe conTroL KnoB
The air volume control knob (F)
controls the air flow and allows for a
MAX of 30 PSI to reduce over-spray
and efficient air consumption.
K
aIr InLeT
The tool's air inlet (G) located at
the bottom of the handle is used for
connecting an air supply that has a
A
standard 1/4" NPT American thread.
FLuID conTroL KnoB
The fluid control knob (I) allows
control of the material amount
released (the density of the
"fan spray").
PaTTern conTroL KnoB
The pattern control knob (H) allows
the width of the "fan spray" to be
adjusted.
B
FIXeD HooK
The spray gun includes a fixed hook
(J) on the body to allow for convenient
hanging when stored.
6
C
D
G
F
J
I
H