Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Release the appliance's latching bar. We recommend you
-
place the appliance flat on the ground. Use a screwdriver to raise the
tongue of the fitting, carefully so as not to distort it. While keeping the
tongue raised, push the latching bar downwards to release the
latches at the top. Pivot the latching bar around the lower latches.
Remove the latching bar.
-
Fix the latching bar. Place the latching bar on the floor against
the wall. Locate the drilling points A. These show you where the lower
fastenings are. Lift the latching lug, aligning it with the drilling point A
to locate the drilling points B. These show you where the upper
fastenings are. Drill the four holes, and insert the plugs. If extra
support is needed, use special plugs (e.g.: in plasterboard). Position
the latching bar and screw in place.
Lock the appliance onto latching bar
Place the appliance at an angle on the supports S1. Pivot the
appliance to place it on the supports S2. Lower the appliance onto
latching bar. The appliance clicks in place, showing it is fixed and
latched. To release the appliance from the latching bar, use a flat-
head screwdriver and push the tongue (top left of the latching bar
behind the appliance) towards the wall. Lift the appliance while
holding the tongue with the screwdriver. Swing it forward then lift it
off the supports S1.
Electric connection
-
The power supply to the appliance is 220 - 230V, 50Hz - 60Hz.
-
In damp atmospheres, such as bathrooms and kitchens, the
junction box must be located at least 25 cm from the floor.
Grounding is forbidden.
Do not install the device above or under a power outlet. The
appliance must be connected to the power supply in accordance with
the standards and regulations in force in the country of installation.
USING HUMIDIFIER MODE (EN)
WARNING: Use only clean, cool tap water to fill the tank. Filtered
or distilled tap water are recommended in hard water areas.
Never use any liquid solution other than the recommended
water and cleaning agent inside this instruction.
Appliance must always be unplugged during filling and
cleaning.
10
Publicidad
