Edesa PREMIUM CHG-BD1/HUM Instrucciones De Uso página 23

ADVICE FOR USERS (EN)
Putting the appliance at its maximum setting will not increase the temperature faster. If you are out for several
hours, consider lowering the temperature. If you have several appliances in one room, let them operate together,
so you have a more uniform temperature and humidity while optimizing power consumption. This also applies
to an empty room; where it is better to let the appliance run at a lower setting, rather than turn it off completely.
TROUBLESHOOTING (EN)
The appliance is not heating: Check that the installation circuit-breakers are engaged. Check the room air
temperature.
The appliance is constantly heating: check the appliance is not in a draught, or whether the temperature
setting has been changed.
The surface of the appliance is very hot: It is normal that the convector is hot when operating, it being
understood that the surface temperature is limited according to the current standard. However, if you feel that
your appliance is still too hot, verify that the power is correct for the surface area of your room (we recommend
2
on average 100 W/m ) and the appliance is not in a draught that would affect its setting.
The humidifier does not work: LED indicator is red - check for water in the humidifier. There is no LED display,
although the backlight function is activated in the Humidifier menu — contact the nearest manufacturer service
center. The LED indicator glows blue, but there is no water vapor - check the steam level in the humidifier
settings, if the water level is low, the steam is not noticeable to the human eye, otherwise contact the nearest
service center of the manufacturer.
The water tank is leaking: make sure that the tank is not full of water and that it is well assembled after
refueling.
Water leakage from the humidifier: make sure the device is vertically installed correctly without tilting.
I do not see the LED display: make sure that the appliance is connected to the power suply and the LED
display is ON in the menu (Humidifier ► LIGHT ► Active), otherwise, contact the nearest service center of the
manufacturer.
I see water under the appliance: make sure that the drain stopper with the gasket is tightly installed. Make
sure that the device is not installed at an angle, otherwise, contact the nearest service center of the
manufacturer.
MODEL SPECIFICATIONS (EN)
Specification
Rated heat output
Minimum heat output
Long-term maximum heat output
At the maximum heat output
At the minimum heat output
In stand-by mode
Specification
Electronic room temperature control and weekly programmer
Room temperature control with user presence sensor
Room temperature control with open window sensor
Remote control option
Adaptive activation control
Activation duration limit
Black globe sensor
Electrical convector with humidifier CHG-BD1/HUM
Heat output
Auxiliary power consumption
Type of heat output/room temperature control
Other control options
Symbol Value
P nom 1.5
P min 0.0
P max 1.5
el max 0.000
el min 0.000
0.29
el sb
0.000
Unit Additional information
Yes
Yes
No
No
Yes
No
No
EN
Unit
kW
kW
kW
kW
kW
W
kW
23