Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Remove the pressing screw and the filter
5.
Remove the juicer bowl
V- TROUBLESHOOTING GUIDE
Problem
Cause
The juicer does
The juicer is not plugged in
not work/start
The detachable parts are not
properly assembled on the base
of the product or the feeding
tube is not properly locked
The
feeding
The pressing screw is not
tube cannot be
inserted
installed
The
attached to the juicer bowl
The juicer stops
The filter and the pressing
while working
screw
normally
The food is cut in too big pieces
The
overheated due to an excessive
amount of fruit or vegetables
The juice does
The anti-drip spout is closed
not come out
The seal of the spout for the
pulp is not positioned correctly
Le joint du bec verseur de pulpe
n'est pas mis correctement
correctly
filter
is
not
properly
are
clogged
juicer
is
too
full
Solution
Check that the device is plugged in
properly
Check that all the parts are assembled
correctly
Check that the pressing screw is pushed
right to the end and positioned
correctly. Check that the filter is
installed correctly
Do not attempt to force the cover open
Turn off the device, unplug it and
remove the cover. Remove the food if
necessary and continue juicing.
or
Turn off the device, unplug it and
disassemble
reassemble
Allow to cool for about 30 minutes
before restarting it.
Open the anti-drip spout
Put the seal back in correctly and check
that it is pushed down properly
Remettez correctement le joint et
vérifiez qu'il soit bien enfoncé
29
it.
Clean
it,
then
the
juicer.
Publicidad
