Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
To keep the warranty valid, never try to repair the
system yourself. If you encounter problems when
using this unit, check the following points before
requesting service.
No power
- Ensure that the AC cord of the apparatus is
connected properly.
- Ensure that there is power at the AC outlet.
- Press standby button to turn the unit on.
Remote control does not work
- Before you press any function button, first select
the correct source.
- Reduce the distance between the remote control
and the unit.
- Insert the battery with its polarities (+/-) aligned as
indicated.
- Replace the battery.
- Aim the remote control directly at the ensor on the
front of the unit.
Poor radio reception
- Increase the distance between the unit and your TV
or VCR.
- Fully extend the FM antenna.
- Connect an outdoor FM antenna instead.
Clock setting erased
- Power has been interrupted or the power cord has
been disconnected.
- Reset the clock.
Using iPhone to play music
- While the iPhone is playing the music throught the
docking, there may be a chance that the iPhone
may not be under a good receiption mode to get the
incoming call signal.
No Response From the Unit
- Disconnect and reconnect the AC power plug, then
turn on the unit again.
Design and specifications are subject to change without notice.
All manuals and user guides at all-guides.com
Specifications
General
- Power Requirements: AC 230V ~ 50Hz
- Power Consumption: 40W
- Output Power: 25W x 2 + 50W
- Total Harmonic Distortion: <1%(1kHz, 1W)
- Audio Input Sensitivity/Impedance: 500mV/47kΩ
- Unit Dimensions (W x H x D: 258 x 328mm
Speaker
Front
- Impedance: 3Ω
- Rate Power: 25W
Woofer
- Impedance: 6Ω
- Rate Power: 50W
Remote
- Distance: 6m
- Angle: 30
Standard Accessories
AC Power cord: x 1
Remote Control: x 1
Owner's manual: x 1
O
17
Publicidad
