Publicidad
Read this first
Read through this installation guide carefully before
you install the product. Keep the installation guide
for future reference.
Electromagnetic compatibility (EMC)
This equipment has been designed and tested to fulfill
applicable standards for:
•
Radio frequency emission when installed
according to the instructions and used in its
intended environment.
•
Immunity to electrical and electromagnetic
phenomena when installed according to the
instructions and used in its intended environment.
USA
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference,
and
2.
this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested using a shielded
network cable (STP) and found to comply with the
limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
when the equipment is operated in a commercial
environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference in which case the
user will be required to correct the interference at his
own expense.The product shall be connected using a
shielded network cable (STP) that is properly grounded.
Contact information
Axis Communications Inc.
300 Apollo Drive
Chelmsford, MA 01824
United States of America
Tel: +1 978 614 2000
Canada
This digital apparatus complies with
CAN ICES-3 (Class A). The product shall be
connected using a shielded network cable (STP) that
is properly grounded. Cet appareil numérique est
conforme à la norme CAN NMB-3 (classe A). Le produit
doit être connecté à l'aide d'un câble réseau blindé
(STP) qui est correctement mis à la terre.
Europe
This digital equipment fulfills the requirements for RF
emission according to the Class A limit of EN 55032.
The product shall be connected using a shielded
network cable (STP) that is properly grounded. Notice!
This is a Class A product. In a domestic environment
this product may cause RF interference, in which case
the user may be required to take adequate measures.
Australia/New Zealand
This digital equipment fulfills the requirements
for RF emission according to the Class A limit of
AS/NZS CISPR 32. The product shall be connected
using a shielded network cable (STP) that is properly
grounded. Notice! This is a Class A product. In a
domestic environment this product may cause RF
interference, in which case the user may be required
to take adequate measures.
When this product has reached the end of its
useful life, dispose of it according to local laws and
regulations. For information about your nearest
designated collection point, contact your local
authority responsible for waste disposal. In accordance
with local legislation, penalties may be applicable for
incorrect disposal of this waste.
Europe
This symbol means that the product shall not be
disposed of together with household or commercial
waste. Directive 2012/19/EU on waste electrical
and electronic equipment (WEEE) is applicable in
the European Union member states. To prevent
potential harm to human health and the environment,
the product must be disposed of in an approved
and environmentally safe recycling process. For
information about your nearest designated collection
point, contact your local authority responsible for
waste disposal. Businesses should contact the product
supplier for information about how to dispose of this
product correctly.
This product complies with the requirements of
Directive 2011/65/EU and 2015/863 on the restriction
of the use of certain hazardous substances in electrical
and electronic equipment (RoHS).
China
This product complies with the requirements
of SJ/T 11364-2014, Marking for the restriction of
hazardous substances in electrical and electronic
products.
有毒有害物质或元素
汞
部
铅
件
(Hg)
(Pb)
名
称
电
气
实
X
0
装
部
分
0: 表示该有毒有害物质在该部件均质材料
中的含量均在GB/T 26572标准规定的限量要
求以下。
X: 表示该有毒有害物质至少在该部件的某一
均质材料中的含量超出GB/T 26572标准规定的
限量要求。
Contact information
Axis Ex AB
Gränden 1
镉
六
多
价
(Cd)
溴
铬
联
(Cr-
苯
(VI))
(PB-
B)
0
0
0
多
溴
二
苯
醚
(PB-
DE)
0
Publicidad
