Weelko MultiEquipment F-336 Manual De Instrucciones página 12

FAQ
If the device produces an abnormal sound:
•
Remove the 4 screws indicated below. These screws
are intended to fasten the pump during transport of
the equipment. It might disrupt the correct pump
vibration during operation and for that reason will
increase the noise of the device.
Diamond dermabrasion
If the suction effect is reduced:
•
Replace the metal and foam filters.
MAINTENANCE
Micro-crystal dermabrasion
•
The filter in container #1 prevents micro crystals
entering the suction circuit of the equipment. 4
replacement filters are delivered. To replace the filter,
unscrew the cap of the container stand, remove the
old filter, insert the new filter and screw the cap
holder.
•
Clean and disinfect the handle and after each
treatment. It is recommended to dip first ultrasonic
sterilizer and subsequently in an ultraviolet sterilizer.
•
Do not use the appliance if the filter tube attached to
the device is not installed.
•
This filter should be replaced every 5 treatments.
•
To replace the filter:
- Unscrew the top of the tank.
- Remove the filter by pulling and insert the new one.
- Screw the top of the tank, making sure the silicone
gasket is positioned correctly.
Note: Before screwing the top, wipe any traces of
micro crystals in the thread and the silicone gasket to
keep a proper sealing.
4 replacement filters are delivered for their
replacement.
Diamond dermabrasion
•
The foam filter in the handle needs to be changed
after every 5 treatments. Dismantle the handle and
replace the filter. Then reassemble the handle.
•
The metal filter in the handle needs to be changed
after every 5 treatments. Dismantle the handle and
replace the filter. Then reassemble the handle.
•
Clean and sterilize the diamond heads after every
treatment.