Publicidad
Idiomas disponibles
Idiomas disponibles
SCOPE OF DELIVERY
ITEM
QTY
A
1
B
5
C
4
D
1
E
2
F
4
1
G
H
1
I
1
J
1
K
1
L
1
Note: The installation and operation of optional parts, please check the corresponding installation guide for details respectively.
REQUIREMENTS FOR MOUNTING
• Do not mount the inverter on flammable building materials.
• Mount the inverter on a solid surface, vertically on the wall.
• Install this inverter at eye level to allow LCD displays to be readable at all times.
• For proper air circulation for heat dissipation, leave a distance of approximately 20cm on the sides of the inverter and 50cm above and below the
unit.
• Ambient temperature in the range of -15 to +60 .
• The slope of the wall must be within ± 5°.
• Be sure to keep other objects and surfaces as shown in the diagram to ensure sufficient heat dissipation and enough space to remove cables.
• The inverter must be installed in a ventilated environment to ensure good heat dissipation.
• Do not install in fresh air directly (indoors only)
• Do not install near the television antenna or the antenna cable.
• Altitude not higher than about 2000 m above sea level.
• Not in precipitation or humidity environment ( 95%).
MANUAL DE USUARIO INVERSOR ÁLAMO
p h o t o v o l t a i c s
ÁLAMO
E
I
Designación
Inverter
Expansion Screws for Fixing Mounting Bracket
M3 Screws for Fixing the inverter
NTC cable
Terminal block SC25-5 for battery cables
Terminal block for PV and AC cables
User manual
PVC tape for NTC cable
Certificate card
WIFI & LAN 2 in 1 optional board (Module & Accessories)
Parallel optional board (Parallel board & Accessories)
LCD Display optional Box (LCD & Accessories)
<15º
G
200
200
20
www.intipv.com
Publicidad
