Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
•
Assemble the cross base by placing the upper part above the other (15) and
tightening the four provided screws.
•
Attach the 4 anti-slip plastic covers (16) to the 4 sides of the cross base.
•
Use the base plastic cover (14) to attach the tube (12) properly and cover the base.
•
Insert the fan body (9) in the tube (12) and tighten the screw (11) to secure it.
•
The height of the fan can be adjusted by using the height adjustment ring (13).
•
Insert the rear grid (5) the grid locking nut (4) the propeller (3), the propeller locking
nut (2) and the front grid (1) on the axis (6).
•
Close and secure by firmly tightening the grid screw and nut through the closing hole.
•
To adjust the tilt, gently push the motor block (7) to the desired vertical position while
holding the fan body with the other hand.
OPERATING INSTRUCTIONS
•
Place your fan on a flat and dry surface and plug it into a suitable mains socket.
•
Make sure the fan is fully assembled before switching on.
•
This device is equipped with 3 speeds. To turn the device on, press one of the speed
buttons. To turn it off, press the "0" button.
Speed Selection :
0 = OFF
1 = soft
2 = moderate
3 = strong
This device also has an oscillation function:
Press the SWING button (*) to switch on the oscillation.
Press the SWING button (*) to switch off the oscillation.
Thanks to the tilting stand, it is also possible to adjust the vertical orientation of the device.
Caution: Never touch the blade with hand or any other objects when the fan is operating.
CARE AND CLEANING
Caution: Always disconnect the fan from mains socket before cleaning.
The propeller blade may have sharp edges. Handle with extreme care.
•
Use only a soft damp cloth to clean the fan.
•
Never spray the appliance with liquids or submerge it in water or other liquid.
•
Never allow water to drip into the motor block.
•
Never use gasoline, paint thinner or other chemicals to clean the fan.
•
If it will not be used for a long period of time, store the fan in a dry place, in its original
box to protect it from dust and humidity.
7
TKG VT 1037 C
Publicidad
