Rockwell Automation AIC+ Instrucciones De Instalación página 6

DIN Rail Mounting (AIC+ and DNI)
Installation
DIN
Rail
Removal
DIN
Rail
Panel Mounting
Template
See back cover for panel mounting template.
Installation
Mounting
Template
Advanced Interface Converter (AIC+) and DeviceNet Interface
1. Mount your DIN rail.
2. Snap the DIN rail latch into the closed
position.
3. Hook the top slot over the DIN rail.
4. While pressing the unit against the rail,
snap the unit into postion.
Latch
1. Place a screwdriver in the DIN rail latch at
the bottom of the unit.
2. Holding the unit, pry downward on the
latch until the unit is released from the DIN
rail.
Side
View
1. Remove the mounting template from the
back of this document.
2. Secure the template to the mounting
surface.
3. Drill holes through the template.
4. Remove the mounting template.
5. Mount the unit.
1761-5.11 - June 1999