Hoover H-FREE 700 Manual De Instrucciones página 9

USING YOUR CLEANER
There are four working modes:
• TEMPORARY MODE: The product will start working when you press on the ON/OFF Switch and stop when released. [3A]
• CONTINUOUS MODE: To enable continuous mode you can pull switch lever back and it will click into place. [3B] To
disable continuous mode you can push the switch lever forward.
• SILENT MODE: Press the silent button to clean thoroughly at the lowest noise level for this product.
• TURBO MODE: Press the Turbo Button to fully power the product for hard cleaning tasks.
IMPORTANT: After each use of your product, please ensure to push the switch lever forward to the unlocked position.
Failure to do so may result in a reduction in battery life or failure.
SELECT SUITABLE ROLLER FOR BEST CLEANING
Intense Floor roller*: It is recommended to use on carpet which can go deep into the carpet to clean the dust.
Deep Care roller*: It is recommended to use on hard floor or delicate parquet. Thanks to the soft bristles you can gently
clean those type of floors.
IMPORTANT: Always switch off the cleaner before changing and cleaning the agitator.
NOTE: To fit the Roller you would like to use: [17]
1. Detach the agitator release button flap. It is positioned on the lateral part of the nozzle.
2. Hold the agitator release flap and pull down to remove the agitator.
3. Replace with Intense Floor Roller or with the Deep Care Roller.
4. Re-fit in position the agitator release flap.
WIPER BLADE ASSEMBLY
To obtain the best crevice and carpet performance, it is recommended to assemble the front and rear wiper blades to
the soleplate of the nozzle.
To do this, open the agitator release flap and remove the soft strip. Then grip one wiper blade, by inserting one end into
the rear slot and slide it in until fully home. Repeat these operations for the second wiper blade and slide it in the front
slot. Lock the agitator release flap. [18]
SAFETY PROTECTION SYSTEM
To ensure the reliability of the product is not affected if used under arduous conditions, the product features an
integrated safety protection system.
NOTE: The Safety protection system will action if the agitator has a blockage or is locked, once actioned, the agitator
will stop rotating and the white Led lights on the front of the nozzle will go out. If this happens, simply turn off your
product and clear the agitator obstruction. To resume cleaning, press the on/off button and the product will start in
normal mode.
BATTERY
DISPLAY Led:
This cleaner is equipped with a Led display. When the product is ON and the display illuminated the indicators show the
following information.
BATTERY LEVEL INDICATOR:
• 4 points = 100% charge
• 3 points = 75% charge
• 2 points = 50% charge
• 1 point = 25% charge
CHARGING
During the charging process if the battery charged level is below 25% you will see the first Led blink until it reaches
above 25%, then it will stay illuminated. This process will continue on all points of the Led indicating level of battery
charge 25%, 50%, 75%, etc. When the battery charge has reached 100% all 4 points will be illuminated.
Please note to ensure your battery is being charged at a safe working temperature we have fitted a safety device. If this
device activates and you commence the charging process then you will see the first Led flash until it has reset. After it
has automatically reset the normal charging process as described above will commence.
DISCHARGING
When the product is running and the batteries are discharging the Led indicator light will start to flash when the battery
capacity is lower than 5% indicating the need to recharge.
* Certain Models Only
4
GB