Beliani ACUARIO RL-6135N Guía De Montaje página 16

Instruction on how to operate our products
1. Turn on the power.
2. Switch on the cold and hot water boilers and adjust the temperature.
3. Use the controller to fill the bathtub with water either from the tap or the handheld shower
head
4. Do not activate the water pump until the water level reaches the jets.
5. Use the air regulator to adjust the massage intensity.
6. Rotate the handheld shower head to adjust the massage effects.
7. The light will turn on and change colours automatically when you turn on the water pump. The
light will switch off when you turn off the water pump.
8. Press the air switch to turn off the pump. Drain the water after use, and finally, turn off the
power.
Troubleshooting
Error
Water pump
not working
Massage jets
do not start
Possible Reasons
The power plug is not properly
connected; the leak protection is not
connected
The water pump impeller is blocked by
something small
The water pump is turned off
The power plug has not been inserted
correctly
Broken water pump
Voltage issue
On/Off button is not on or not
functioning
Water circulation is blocked
Try This
Plug in the power plug and connect
the leak protector
Clean the water pump impeller
Turn on the water pump.
Plug in the power supply correctly
Repair or replace the water pump
Check the voltage
Check the switch or replace it
Clean the water pipes
16