Beliani ACUARIO RL-6135N Guía De Montaje página 17

Bathtub is not
level
Water overflow
Cleaning
1. Use a soft cloth for cleaning purposes, avoiding the use of strong detergents that contain
acetone or ammonia. It is strictly prohibited to disinfect using formic acid or formaldehyde.
2. If there is a scratch on the surface, utilise 2000-grit wet sandpaper to gently polish it.
Afterwards, proceed to polish it further using toothpaste and a soft cloth.
3. Limescale deposits can be removed using vinegar or lemon juice.
4. If the water circulation is blocked, unscrew the nozzles and pipes and clean them.
5. Frequent cleaning is not necessary for the gold-plated and silver-plated components.
6. Please refrain from striking the bathtub with hard objects. Additionally, please avoid direct
contact between the bathtub and hot items that exceed a temperature of 70 °C (e.g.,
cigarettes). Do not clean the bathtub with chemical substances that contain bleach.
7. Drain the water and unplug the power cord after use.
8. Cleaning the water massage system: Fill the bathtub with 40 °C hot water and add 2g of
detergent per litre. Let the massage system run for 5 minutes. Afterwards, stop it and drain the
water. Refill the bathtub with cold water and activate the massage system for 3 minutes. You
can now drain the water again, and your massage jets are cleaned.
Precautions
1. Installation should be carried out by a qualified plumbing installer. Please follow the
instructions provided in the manual.
2. Appropriate hoses should be acquired from local sources and connected by a specialist. Under
no circumstances should any connecting hoses provided by the seller be utilised.
Adjustable feet are not set correctly
Overflow drain is defective
Nuts are loose
Connecting parts are not correctly
attached
Adjust the feet
Replace the overflow drain
Tighten the nuts
Inspect the adhesive of the connecting
parts
17