Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Tightening
•
•
•
•
•
•
•
8
Fit an extension (not included) if required to the
head (A).
Set ratchet function direction on the direction
changer (B).
Install properly sized socket/attachment to the
square drive (A).
Set the direction switch (B) to tighten position.
Operate the torque wrench the same as a
standard socket wrench to tighten the bolt/nut.
Place the socket on bolt/nut and tighten slowly
and steadily until the "click" sound is heard. Stop
pulling the wrench and release the pressure on
the handle (E). The bolt/nut is now tightened to
the required torque setting.
Do not continue to pull after the torque setting is
reached. Doing so will over-tighten the bolt/nut
and could damage the wrench.
A
B
Publicidad
