Section 3 − Installation; Required Torch Parts And Torch Assembly; International Style Connector Assembly - WeldCraft CS31012 Manual Del Operador

3-1. Required Torch Parts And Torch Assembly

Assembling Torch Parts
3
2
1
15

3-2. International Style Connector Assembly

1
2
Tools Needed:
OM-225 426 Page 4
SECTION 3 − INSTALLATION
6
5
4
7
10
9
14
3
(26 mm)
3
8
11
13
1 in
5
4
1 Cup
2 Collet Body
3 Heat Shield
4 Collet
5 O-Ring
6 Backcap
7 Torch Body
8 Handle
9 Power Cable
10 Water Hose
11 Gas Hose
12 Power Cable Adapter
13 International Style Adapter
14 Water Hose For International
Style Adapter
Assembling Torch Body
12
Keep connections tight. Replace
cup, heat shield, and backcap as
needed.
15 Tungsten Electrode (See Sec-
tion 5)
Installing Tungsten
To adjust tungsten position, loosen
backcap.
1 Weld Output Cable
2 Insulating Boot
3 Sleeve
Slide insulating boot onto cable;
strip cable and install sleeve.
4 Connector Body
5 Setscrew
Insert cable with sleeve fully into
connector body, tighten setscrew,
and slide insulating boot over con-
nector.
804 302-A
ST-156 496