Publicidad
Idiomas disponibles
Idiomas disponibles
When the light has been off for over 60 seconds, and is first turned on, it will come on in white for
15 seconds, then go to the last fixed color or color show that was running. Note: Do not power cycle
the light during the first 15 seconds of white to preclude risk of loss of synchronization with other
connected lights.
When in UCL mode, the light has the capability to display 17 different programs; 10 fixed colors
and 7 color-changing shows. These programs are advanced using power-cycling − quickly toggling
power to the light. The programs are listed below:
1.
Show-Voodoo Lounge
2.
Fixed-Deep Blue Sea
3.
Fixed-Royal Blue
4.
Fixed-Afternoon Skies
5.
Fixed-Aqua Green
6.
Fixed-Emerald
If you have multiple lights running together and they become out of sync, you can resync the lights
by following the steps below:
1.
Turn lights on.
2.
Turn off light for between 11-15 seconds,.
3.
Turn lights on.
When the lights come on, they should enter program #1 (Voodoo Lounge), and be synchronized.
Omni Automation Control
When using an Omni controller, the light can be set to Omni Direct mode which allows for direct
toggling to the selected show/color as well as 10 additional fixed color options, brightness control,
and speed control. Refer to the Configuration section of your Omni controller manual for instructions
on configuring a light and configuring a water feature. Note that the light mode can be changed from
the configuration menu of the Omni control, but if the mode needs to be changed manually, follow
the procedure on the following page.
When configuration is complete, turn on the water feature from the Omni controller. Adjust the flow
control valve
or pump speed
To activate the light from the Omni control, simply navigate to the light menu and press the on/off.
The light show can also be changed from this menu, schedules can be set, and the brightness and
speed of the light can be adjusted.
When the light has been off for over 60 seconds, and is first turned on, it will come on in white for
15 seconds, then go to the last fixed color or color show that was running. Note: Do not power cycle
the light during the first 15 seconds of white to preclude risk of loss of synchronization with other
connected lights.
11
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
7.
Fixed-Cloud White
8.
Fixed-Warm Red
9.
Fixed-Flamingo
10. Fixed-Vivid Violet
11. Fixed-Sangria
12. Show-Twilight
until the ideal water effect is achieved.
13. Show-Tranquility
14. Show-Gemstone
15. Show-USA
16. Show-Mardi Gras
17. Show-Cool Cabaret
Publicidad
