Manual-Mode; Display-Button; Programming; Chaser - Futurelight CP-240 Manual Del Usuario

6.1 Manual-mode

6.1.1 Call up projectors manually
In the Manual-mode (Program-LED off), you can call up the connected projectors manually and control them
via the channel faders. Please note that the adjusted settings cannot me memorized.
Select the desired projector via the respective projector select button.
Adjust the desired function via the channel faders.
Page Select-button:
Via the Page Select-button, you can adjust the channel faders from CH 1-8 to CH 9-16.

Display-button:

Via the Display-button, you can switch the display of the faderway from DMX-value (0-255) to procent (0-
100).

6.2 Programming

A program is a sequence of different scenes that will be called up one after another. With the CP-240, you
can program up to 30 different programs (banks) with up to 8 scenes each.
6.2.1 Programming a program
Press and hold the Program-button until the Program-LED flashes in the display.
Select the desired projector via the projector select buttons. Adjust the desired settings via the respective
channel faders. Select the next projector via the projector select buttons and adjust the settings. Press the
Rec-button. Select the desired program (bank) via the Bank-buttons. Press the respective Scene-button in
order to save the first step. All LEDs on the panel will flash indicating your settings are saved. Program the
next steps until the program is finished or the maximum number of steps - 8 - has been reached. Press and
hold the Program-button in order to exit the program mode. The controller is now in the blackout-mode
(Blackout-LED illuminated).
6.2.2 Running a program
Press the Bank-buttons and select the desired program. Press the Auto-button and the Auto LED is
illuminated in the display. Adjust the program speed via the Speed-Fader and the repitition rate via the Fade
Time-Fader.
As an alternative, you can adjust the program speed by tapping the Taph-button twice. The time interval
between the two taps corresponds to the program speed (up to 10 minutes).
6.2.3 Checking a program
Press and hold the Program-button and select the desired program via the Bank-buttons. Check every scene
individually by pressing the respective Scene-button.
6.2.4 Editing a program
Should you notice that a scene does not correspond to your imagination or when programs have to be edited
for a new stage, it is necessary to modify a scene manually.
Press and hold the Program-button and select the desired program via the Bank-buttons.
Select the desired scene via the scene button. Select the desired projector via the projector select buttons.
Adjust the desired settings via the respective channel faders. Select the next projector via the projector
select buttons and adjust the settings. Press the Rec-button and the respective Scene-button in order to
save the edited step. Edit the next steps until the program is finished. Press and hold the Program-button in
order to exit the program mode.

6.3 Chaser

A chaser is a sequence of different programs and/or scenes that will be called up one after another. With the
CP-240, you can program up to 6 different chasers with up to 240 steps.
6.3.1 Programming a chaser
Press and hold the Program-button. Select the desired chaser via the Chase-buttons.
Select the desired program via the Bank-buttons. Select the desired scene via the Scene-buttons. Press the
Rec-button. Program the next steps until the chaser is finished or the maximum number of steps - 240 - has
been reached. Press and hold the Program-button in order to save the chaser.
20/41 51834265_V_1_2.DOC