Set-Up And Basic Adjustment; Adjustment Of Port-A-Filter Clamp - Puqpress M1 Manual De Instrucciones

6 Bolt to fasten lower clamp
7 Display
8 Drip tray
9 Tag label
10 back plate
11 feedback signal (only for model 2-001-010X-1)
12 ON/OFF switch
13 Bottom side: power entry
4

Set-up and basic adjustment

You have received your tamper in operating condition. Now you only
need to adjust the port-a-filter clamp, connect the tamper to the
power grid and insert drip tray. Proceed as follows:

4.1 Adjustment of port-a-filter clamp

The tamper is designed so that all different port-a-filters from
various espresso machines fit into the clamp ( pos.4 & 5 ) for even
and level tamping.
If the port-a-filter clamp is not correctly adjusted, even and level
tamping cannot be guaranteed!
Proceed as follows for adjustment of the port-a-filter clamp:
1. Retract the power cord from the socket at the back side.
2. Lay down the tamper with the top side on a table and secure the
tamper.
Precision coffee tamper
EN
7